Filter
Top Products
SKU 91315 For technical questions, please call 1-800-444-3353. Page 10
To Fill The Oil Tank With Hydraulic Oil:
The hydraulic Oil Tank (13A) has a holding capacity of 6.5 quarts. To ll the Oil
Tank, squeeze and hold the Brake Lever (13B) to release any load on the Scissor
Lift. Remove the Oil Tank Fill Cap on the Oil Tank. Add a premium quality
hydraulic oil until the level of the oil is even with the Oil Tank’s ll hole. Then,
replace the Oil Tank Fill Cap. (See Figure D.) Before the rst use and before
all subsequent uses, check the hydraulic oil tank to make sure the Oil Tank is
properly lled.
OPERATING INSTRUCTIONS
Check The Safety Lock Assembly:
BRAKE STEEL CABLE
(10B)
GENERAL INLET PIPE
(18B)
SAFETY LOCK ASSEMBLY
(1C THROUGH 11C)
RUBBER SADDLE
(39B)
PLATE
(42B)
FIGURE E
WARNING! Never operate the Scissor Lift if the Safety Lock Assembly
(1C through 11C) is not working properly. (See Figure E.)
Insert the Power Plug (not included) of the Lift into a properly grounded, 3-hole,
220 volt electrical receptacle, and allow several seconds for the Motor (1A) to
warm up. (See Figure D.)
Squeeze and release the Brake Lever (13B) several times and, while doing so,
observe that the Safety Lock Assembly (1C through 11C) operates properly in
1.
2.
3.
REV 07j