Filter
Top Products
9. Connect the other end of the negative(−) cable to
the remote negative (−) terminal, on the vehicle
with the dead battery.
10. Now start the vehicle with the good battery and run
the engine for a while.
11. Try to start the vehicle that had the dead battery.
If it will not start after a few tries, it probably needs
service.
Notice: If the jumper cables are connected or
removed in the wrong order, electrical shorting may
occur and damage the vehicle. The repairs would
not be covered by the vehicle warranty. Always
connect and remove the jumper cables in the
correct order, making sure that the cables do not
touch each other or other metal.
Jumper Cable Removal
A. Heavy, Unpainted Metal Engine Part or Remote
Negative (−) Terminal
B. Good Battery or Remote Positive(+) and Remote
Negative (−) Terminals
C. Dead Battery or Remote Positive(+) Terminal
To disconnect the jumper cables from both vehicles do
the following:
1. Disconnect the black negative(−) cable from the
vehicle that had the bad battery.
2. Disconnect the black negative(−) cable from the
vehicle with the good battery.
7-48