Filter
Top Products
Disabling and Resetting IntelliBeam
®
at the
Rearview Mirror
IntelliBeam
®
can be disabled by using the controls on
the inside rearview mirror.
AUTO
3 (On/Off): To disable the system, press this
button on the inside rearview mirror. The IntelliBeam
®
indicator will turn off and will not come back on until the
IntelliBeam
®
button is pressed again.
(Stalk Disable): When IntelliBeam
®
has turned on the
high-beams, pull or push the high-beam stalk. This will
disable IntelliBeam
®
. The IntelliBeam
®
indicator on the
mirror will turn off. To re-enable IntelliBeam
®
, press the
IntelliBeam
®
button on the mirror.
A different sensitivity setting is available for dealer
diagnostics. This is done by pushing and holding this
button for 20 seconds until the IntelliBeam
®
indicator
light flashes three times. If you accidentally activate
this, the vehicle's setting will automatically be reset
each time the ignition is turned off and then on again.
Cleaning the IntelliBeam
®
Light Sensor
The light sensor is located
on the inside of the
vehicle in front of the
inside rearview mirror.
Clean the light sensor window, periodically, using glass
cleaner on a soft cloth. Gently wipe the sensor window.
Do not spray glass cleaner directly on the surface of the
sensor window.
4-14