200
Chapter 9 PGL Commands
Select Format (SF) Command
(Normal, Create, and Execute)
These commands allow you to configure PGL to ignore characters from 00 to
0F Hex. This enables the printer to ignore all host-generated paper movement
commands.
When SF Mode is activated you may still send paper movement commands
by using one of the following commands.
Enter Result
CR Carriage Return
LF Line Feed
FF Form Feed
These commands will have no effect after the SFOFF Command has been
sent.
Table 37. Set Format Commands
Field Function Option/Modifier Selections
SFON
SFON
Turns Select Format Mode on. The
printer ignores all characters from
00 to 0F Hex until it receives the
SFOFF sequence.
Enter the current Special Function Control
Character followed by SFON.
SFOFF
SFOFF
Turns Select Format Mode off. The
printer begins processing normally.
Enter the current Special Function Control
Character followed by SFOFF.
