3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 19
SS
SS
S
tep 7tep 7
tep 7tep 7
tep 7
AA
AA
A
ttach Sttach S
ttach Sttach S
ttach S
tainless Stainless S
tainless Stainless S
tainless S
teel Bteel B
teel Bteel B
teel B
rake Linerake Line
rake Linerake Line
rake Line
Install the caliper end of the stainless steel brake
line by first placing a copper crush washer on
either side of the banjo fitting, then inserting the
banjo bolt into the fitting.
Copper
Banjo bolt
Insert the banjo bolt into the caliper, angling the
banjo fitting so that it is leaning slightly forward.
NN
NN
N
ote: Dote: D
ote: Dote: D
ote: D
o not use a toro not use a tor
o not use a toro not use a tor
o not use a tor
que wrque wr
que wrque wr
que wr
ench, as oench, as o
ench, as oench, as o
ench, as o
vv
vv
v
er-er-
er-er-
er-
tightening the bolt can strip the aluminumtightening the bolt can strip the aluminum
tightening the bolt can strip the aluminumtightening the bolt can strip the aluminum
tightening the bolt can strip the aluminum
threads, causing irreparable damage to thethreads, causing irreparable damage to the
threads, causing irreparable damage to thethreads, causing irreparable damage to the
threads, causing irreparable damage to the
calipercaliper
calipercaliper
caliper
..
..
.
Torque the banjo bolt to
apprappr
apprappr
appr
oo
oo
o
ximately 14 lb-ximately 14 lb-
ximately 14 lb-ximately 14 lb-
ximately 14 lb-
ftft
ftft
ft, using a 14mm wrench or socket.
Use an 11/16” wrench to hold the stainless line
fitting, while using a 13mm flare wrench to
tighten the hard line fitting.
Remove the rubber cap from the hard line, and
screw the stainless steel brake line onto the hard
line fitting by hand for a few turns.
