15. Test Commands
4200-A2-GB20-00 August 2002
15-9
RLS-LPBK-VCL
The RLS-LPBK-VCL command releases any loopback currently active on the
selected ATM VCL.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* RLS-LPBK-VCL:[tid]:aid_vcl:[ctag][:] */
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* RLS-LPBK-VCL:[tid]:aid_vcl:[ctag][:] */
aid:ERRCDE=errcde
/* error description */
;
Table 15-7. RLS-LPBK-VCL Command Parameters
RLS-LPBK-VCL:[tid]:aid_vcl:[ctag][:];
RESTRICTION: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_vcl Access identifier for the ATM virtual channel. The value can be
preceded with AID=, but this is not required. Grouping and ranging are
allowed. Enter in the following format, replacing lower-case parameters
with the values given:
NTVCL-rack-shelf-slot-circuit-vpi-vci: VCL for NT circuit
LTVCL-rack-shelf-slot-circuit-vpi-vci: VCL for LT circuit
– rack: rack number (1)
– shelf: shelf number (1)
– slot: LT slot number (1)
– circuit: ADSL circuit on the NT/circuit on the LT (1)
– vpi: Virtual Path Identifier
– vci: Virtual Channel Identifier
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
