6. Cross Connect Commands
4200-A2-GB20-00 August 2002
6-7
ENT-CRS-VC
The ENT-CRS-VC command establishes a VC-level cross-connection between the
NT and LT.
Table 6-5. ENT-CRS-VC Command Parameters
ENT-CRS-VC:[tid]:nt_vcl,lt_vcl:[ctag]::::[pst];
RESTRICTIONS: All parameters in this command are position-defined. The range of
values for vpi and vci is determined by the number of VPI and VCI bits allocated. View the
number of bits allocated with the RTRV-PROFILE-ATMACC command.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
nt_vcl Virtual Channel Identifier for the Virtual Channel Link on the NT
(network) side. Enter in the following format, replacing lower-case
parameters with the values given:
NTVCL-vpi-vci
– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0−15)
– vci: Virtual Channel Identifier for the Virtual Channel Link (for LT
vpi=32−63, for NT vpi=32−1023)
Grouping is allowed for up to 8 AIDs. Ranging is allowed.
lt_vcl Virtual Channel Identifier for the Virtual Channel Link on the LT (user)
side. Enter in the following format, replacing lower-case parameters with
the values given:
LTVCL-rack-shelf-slot-circuit-vpi-vci: Virtual Channel in the NT
– rack: Rack number (1)
– shelf: Shelf number (1)
– slot: LT slot number (1)
– circuit: ADSL circuit on the LT (1−24)
– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0−15)
– vci: Virtual Channel Identifier (for LT vpi=32−63,
for NT vpi=32−1023)
Grouping and ranging are allowed. If these features are used, the two
sets of AIDs must match one-to-one.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
[pst] Desired Primary State. Valid values are:
IS: In-Service (default)
OOS: Out-Of-Service (OOS-MA is implied)
If no value is specified, IS is assumed.
