8. IP Access Commands
4200-A2-GB20-00 August 2002
8-19
RTRV-IPPORT
The RTRV-IPPORT command retrieves configuration data associated with an
Internet Protocol port in the NE.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* RTRV-IPPORT:[tid]:aid_ipport:[ctag] */
aid_ipport:cfg_mode:[ipport_nblk]::::pst
;
Table 8-15. RTRV-IPPORT Command Parameters
RTRV-IPPORT:[tid]:aid_ipport:[ctag][::::[pstf]];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_ipport Access identifier of the IP port. The value can be preceded with AID=,
but this is not required. The valid values are:
ATM-1: First IP-over-ATM interface in the NT
ATM-2: Second IP-over-ATM interface in the NT
ETH-1: First Ethernet interface in the NT
Grouping is allowed and ALL may be used.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
pstf Primary State Filter. Valid values are:
IS: Retrieve in-service entities only.
OOS: Retrieve out-of-service entities only.
If no value is specified, this filter is ignored.
