Effective 4/00
Page 15
IL 33-FX6-1
K. Route the Sensor Harness under the Aux. CT
Module to the rear of the Assembly.
NOTE: Steps 9-A through 9-I are performed with
the Trip Unit Assembly on the work bench,
close to the front of the Breaker.
A. Connect the “+” DTA Wire to the “OP” terminal
of the Aux. CT Module’s 7-Point Terminal Block
and the unmarked wire to the “ON” terminal.
Fig. 27 Sensor Harness Connections
Fig. 28 Routing of the Sensor Harness
STEP 9: INSTALLING THE TRIP UNIT
ASSEMBLY
Fig. 29 Overview: Trip Unit Assembly Installed in
the Breaker
Fig. 30 DTA Wires Connected to the 7-Point
Terminal Block
Connect the green ground wire from the
Sensor Harness (with the ring terminal) to the
right side (top) of the Aux. CT Module, as
shown, using the (1) .190-32 × .375" screw,
(1) lock washer, and (1) flat washer supplied.
