NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed
only by Dell certified service technicians.
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Keep the #2 Phillips screwdriver ready.
4. Remove the bezel assembly.
Steps
1. Turn the sled over with the bottom side of the sled facing up.
2. Align the bezel assembly with the sled front panel and push the assembly into the sled until it is fully
seated.
3. Install the screws securing the bezel assembly to the bottom side of the sled.
4. Turn the sled over with the top side of the sled facing up.
5. Install the screws securing the bezel assembly to the top of the sled.
6. Close the drive drawer.
7. Using a #2 Phillips screwdriver, turn the sled locks to unlock position.
8. Align the service caution label and paste the label on top of the drive drawer.
Next steps
1. Install the Mini Enterprise Service Tag (MEST).
2. Follow the procedure listed in After working inside your system.
Related Links
Removing the bezel assembly
Installing the Mini Enterprise Service Tag
40
