NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed
only by Dell certified service technicians.
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Keep the T15 Torx screwdriver ready for the storage controller module (SCM) cable screws.
4. Keep the #2 Phillips screwdriver ready for the screws securing the SCM to the module holder.
5. Remove the storage controller module.
Steps
1. Align the SCM with the connector on the midplane interface module.
2. Lower the SCM until it is firmly seated on the connector on the midplane interface module.
3. Install the screws to secure the SCM to the module holder on the midplane interface module.
4. Holding the module cable touch point, align the cable guide pins with the holes on the SCM.
5. Tighten the screws to secure the SCM cable to the module.
Next steps
1. Close the drive drawer.
2. Follow the procedure listed in After working inside your system.
NOTE: The replacement storage controller module is set to HBA mode by default. After
replacing a RAID mode licensed storage controller module, you must set the replacement
module to RAID mode.
3. Set the replacement storage controller module to RAID mode by using the PERC BIOS Configuration
Utility (Ctrl+R) or the Human Interface Infrastructure (HII) utility.
Related Links
Removing the storage controller module
Opening the drive drawer
Closing the drive drawer
Removing the storage controller module
Closing the drive drawer
Bezel assembly
The bezel assembly on the storage sled front panel comprises the drive drawer handle and the Mini
Enterprise Service Tag.
Removing the bezel assembly
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To prevent damage to the storage sled locks, use a #2 Phillips screwdriver to turn the
sled locks to lock or unlock positions.
37
