• FD33xS—storage controller module with single PERC
• FD33xD—storage controller module with dual PERC
NOTE: The default mode for the storage controller module is HBA mode. To enable RAID mode for
the SCM, you must upgrade to RAID mode licensing. For more information on RAID mode licensing,
see the PowerEdge FX2s CMC User’s Guide at dell.com/esmmanuals. For information on how to
import RAID mode license, see the Dell PowerEdge FX2/FX2s CMC Online Help.
For more information on the storage controller modules, and removing and installing the SCM
components, see the Dell PowerEdge RAID Controller (PERC) 9 User’s Guide at dell.com/
storagecontrollermanuals.
Removing the storage controller module
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed
only by Dell certified service technicians.
NOTE: You must remove the storage controller module (SCM) to replace a faulty module.
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Keep the T15 Torx screwdriver ready for the storage controller module cable screws.
4. Keep the #2 Phillips screwdriver ready for the screws securing the storage controller module to the
module holder.
Steps
1. Open the drive drawer until the storage controller module is accessible.
2. Loosen the screws securing the module cable to the SCM.
3. Lift the module cable away from the SCM by holding the cable touch point.
4. Holding the touch point, allow the module cable to slowly retract into the cable coil.
5. Remove the screws securing the SCM to the module holder on the midplane interface module.
6. Holding the SCM by the touch points, lift the SCM from the connector on the midplane interface
module.
35
