4
Installing and removing storage sled
components
This section provides information on installing and removing the storage sled components. For
information on removing and installing the compute sled components, see the relevant sled Owner’s
Manual at dell.com/poweredgemanuals. For information on installing and removing the enclosure
components, see the enclosure Owner's Manual at dell.com/poweredgemanuals.
Customer and field replaceable units—PowerEdge FD332
The following components are customer replaceable units (CRUs):
• hard drive/SSD assembly
• storage controller module batteries
NOTE: For information on removing and installing the storage controller module batteries, see
the Dell PowerEdge RAID Controller (PERC) 9 User’s Guide at dell.com/
storagecontrollermanuals.
The following components are field replaceable units (FRUs). Removal and installation procedures of the
FRUs should be performed only by Dell certified service technicians.
• Hard drives/SSDs from drive rails
• Mini Enterprise Service Tag (MEST)
• Storage controller module
• Bezel assembly
Safety instructions
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: It is recommended that you always use an antistatic mat and antistatic strap while working
on components inside the system.
Before working inside your system
1. Turn off the compute sled(s) to which the storage sled is mapped, by using the CMC, iDRAC, or the
power button on the compute sled.
When the sled is turned off, its front panel power indicator is off.
17
