Filter
Top Products
Periodic maintenance and adjustment
68
2. Lift the rear of the snowmobile onto a suit-
able stand to raise the drive track off the
ground.
3. Start the engine and rotate the drive track
one or two turns. Stop the engine.
4. Check the drive track alignment with the
slide runners. If the alignment is incorrect,
loosen the locknut on the left and the right
sides of the snowmobile, then align the
drive track by turning the adjusting bolt on
each side.
Shifted to right
1. Rear axle nut
1. Slide runner
Drive track
alignment
Shifted to
right
Shifted to left
Left adjusting
bolt
Turn out Turn in
Right adjust-
ing bolt
Turn in Turn out
1
1
1. Left adjusting bolt
2. Right adjusting bolt
3. Locknut
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
31 23
U8FP15E0.book Page 68 Thursday, July 23, 2009 11:01 AM