Filter
Top Products
Control functions
29
RX10MT
WARNING
EWS00770
The left and right adjusting nuts must be
set to the same position. Uneven settings
can cause poor handling and loss of sta-
bility.
1. Loosen the locknut while holding the ad-
justing nut.
2. To increase weight transfer, turn the ad-
justing nut in direction (a), and to de-
crease weight transfer, turn it in direction
(b). WARNING! Never adjust the con-
trol rods beyond the maximum set-
ting, indicated by red paint; otherwise,
they could be damaged, which could
lead to an accident or injury.
[EWS00173]
1. Special wrench
Locknut tightening torque:
35 Nm (3.5 m·kgf, 25 ft·lbf)
1
1. Locknut
2. Control rod adjusting nut
U8FP15E0.book Page 29 Thursday, July 23, 2009 11:01 AM