Filter
Top Products
Periodic maintenance and adjustment
67
material is visible or support rods are
broken. Otherwise, track damage or fail-
ure could result in loss of braking ability
and snowmobile control, which could
cause an accident.
Checking the drive track
WARNING
EWS00490
Do not operate the snowmobile if you find
damage to the drive track, or if it has been
maladjusted. Drive track damage or failure
could result in loss of braking ability and
snowmobile control, which could cause
an accident.
Check the drive track deflection, and check
the track for wear and damage.
Adjust or replace if necessary. (See the fol-
lowing section for more details.)
Measuring the drive track deflection
1. Lay the snowmobile on its side.
2. Measure the drive track deflection with a
spring scale. Pull at the center of the drive
track with a force of 100 N (10 kgf, 22 lbf).
TIP
Measure the gap between the slide runner
and the edge of the track window. Measure
both sides.
3. If the deflection is incorrect, adjust the
drive track.
Adjusting the drive track (RX10R / RX10LT)
1. Loosen the rear axle nut.
1. Spring scale
1. Drive track deflection
2. Slide runner
Standard drive track deflection:
30.0–35.0 mm (1.18–1.38 in)
2
U8FP15E0.book Page 67 Thursday, July 23, 2009 11:01 AM