Filter
Top Products
Periodic maintenance and adjustment
47
To install a side cover
1. Place the side cover in the original posi-
tion, and then tighten the fasteners.
2. Install the shroud.
TIP
Be sure to fit the projection on the rear of the
side cover into the hole in the lower side cov-
er.
Top cover
To remove the top cover
1. Remove the shroud. (See the above pro-
cedure.)
2. Remove the screws, and then remove
the cable guide.
3. Loosen the quick fastener screws, dis-
connect the main switch coupler and aux-
iliary DC jack coupler, and then remove
the top cover.
1. Fastener
2. Right side cover
1. Fastener
2. Left side cover
1. Screw
2. Cable guide
1. Quick fastener screw
2. Top cover
3. Auxiliary DC jack
4. Main switch
2
1
1
43
U8FP15E0.book Page 47 Thursday, July 23, 2009 11:01 AM