Filter
Top Products
Periodic maintenance and adjustment
46
ESU11741
Tool kit
The service information included in this man-
ual and the tools provided in the owner’s tool
kit are intended to assist you in the perfor-
mance of preventive maintenance and minor
repairs. However, additional tools such as a
torque wrench may be necessary to perform
certain maintenance work correctly.
NOTICE
ECS00360
Before starting the engine, make sure that
the tool kit is properly seated in its holder
and is securely fastened.
TIP
If you do not have a torque wrench available
during a service operation requiring one, take
your snowmobile to a Yamaha dealer to
check the torque settings and adjust them if
necessary.
ESU12894
Removing and installing the
shroud and covers
WARNING
EWS00091
Be sure shroud and covers are secured
before operation. A loose shroud or cover
could move and cause loss of control.
Shroud
To remove the shroud
Loosen the fasteners, slowly raise the shroud,
and then unhook the shroud from the shroud
stay.
To install the shroud
Hook the end of the shroud onto the shroud
stay, slowly lower it to the original position,
and then tighten the fasteners.
Left and right side covers
To remove a side cover
1. Remove the shroud. (See the above pro-
cedure.)
2. Loosen the fasteners, and then remove
the side cover.
1. Tool kit
1. Fastener
2. Shroud
3. Shroud stay
1. Shroud stay
2
1
3
U8FP15E0.book Page 46 Thursday, July 23, 2009 11:01 AM