Filter
Top Products
Periodic maintenance and adjustment
67
3. Tighten the quick fastener screws.
4. Place the windshield stay rubber covers
in their original position.
5. Install the handlebar cover.
6. Connect the auxiliary DC jack coupler.
7. Install the left side cover and the shroud.
NOTICE
ECS00372
● Make sure that all cables, hoses and
leads are routed properly before install-
ing the shroud and covers.
● When installing the shroud and covers,
be sure to tighten the fasteners secure-
ly.
ESU13962
Opening and closing the
shroud and removing and in-
stalling the right side cover
(RST90)
WARNING
EWS00810
Be sure the shroud and right side cover
are secured before operation. A loose
shroud or cover could move and cause
loss of control.
Shroud
To open the shroud
Unhook the shroud latches, and then slowly
raise the shroud forward until it stops.
To close the shroud
Slowly lower the shroud to its original position,
and then hook the shroud latches.
Right side cover
To remove the right side cover
1. Open the shroud. (See the above proce-
dure.)
2. Remove the screws and bolts, and then
remove the right side cover.
To install the right side cover
1. Place the right side cover in the original
position, and then tighten the bolts and
screws.
2. Close the shroud.
1. Shroud latch
2. Shroud
1. Screw
2. Bolt
3. Right side cover
2
1
1
3
2 1
U8JA11E0.book Page 67 Monday, June 14, 2010 10:22 AM