Filter
Top Products
Control functions
14
Odometer and tripmeter modes
Pushing the “SELECT” button switches the
display between the odometer mode “ODO”
and the tripmeter modes “TRIP A” and “TRIP
B” in the following order:
ODO → TRIP A → TRIP B → ODO
If the fuel level warning indicator and warning
light come on (see page 18), the odometer
display will automatically change to the fuel
reserve tripmeter mode “F-TRIP” and start
counting the distance traveled from that point.
In that case, push the “SELECT” button to
switch the display between the various trip-
meter and odometer modes in the following
order:
F-TRIP → ODO → TRIP A → TRIP B → F-
TRIP
To reset a tripmeter, select it by pushing the
“SELECT” button, and then push the “RE-
SET” button for at least 1 second. If you do not
reset the fuel reserve tripmeter manually, it
will reset itself automatically, and the display
will return to the prior mode after the snowmo-
bile has been refueled and traveled 5 km (3
mi).
Oil change tripmeter
When the periodic oil change interval is
reached at the initial 800 km (500 mi), then at
every 4000 km (2500 mi) thereafter, the oil
change tripmeter and “OIL” flash alternately in
the odometer display, and the tripmeter starts
counting the distance traveled from that point.
When this occurs, change the engine oil as
soon as possible. (See page 77 for the oil
change procedure.)
TIP
● The oil change tripmeter will flash only
when the snowmobile is stopped.
● To return to the previous display mode,
push the “SELECT” button. To display the
oil change tripmeter again, turn the key to
the off position, then back to the on position.
After changing the engine oil, reset the oil
change tripmeter as follows.
To reset the oil change tripmeter (when the
engine oil was changed after the oil change
tripmeter appeared)
1. To display the oil change tripmeter, turn
the key to the on position.
2. Push the “RESET” button for at least 1
second while the oil change tripmeter and
“OIL” are flashing alternately in the odom-
eter display. The distance traveled since
the last oil change and “OIL” will flash al-
ternately in the odometer display.
3. Push the “RESET” button for approxi-
mately 3 seconds. “00000” and “OIL” will
flash alternately in the odometer display 3
times, and then the display will return to
the previous display mode.
1. Odometer/tripmeter/fuel reserve tripmeter
E LO
1
E LO
U8JA11E0.book Page 14 Monday, June 14, 2010 10:22 AM