Filter
Top Products
Operation
56
TIP
The reverse buzzer beeps while the shift lever
is in reverse.
2. While squeezing the brake lever, release
the parking brake by moving the parking
brake lever to the right, and then release
the brake lever.
3. Squeeze the throttle lever slowly to start
out.
4. Turn the handlebar in the desired direc-
tion.
5. Squeeze the brake lever to stop the
snowmobile.
6. Apply the parking brake by moving the
parking brake lever to the left.
ESU11411
Stopping the engine
● Turn the main switch to the off position to
stop the engine.
● Push down the engine stop switch to stop
the engine in an emergency.
ESU13780
Transporting
When transporting your snowmobile on a trail-
er or in a truck, observe the following recom-
mendations to help protect it from damage:
● RST90: Make sure that the fuel level in the
fuel tank is lower than the bottom of the car-
buretors. Otherwise, the vibration and
bumps from the road surface could make it
possible for fuel to flow through the carbu-
retors into the cylinders. This can result in
“hydrostatic lock,” a condition where the en-
gine cannot rotate because of fuel accumu-
lated in the engine. Severe engine damage
can result from hydrostatic lock. When pos-
sible, the fuel tank should be empty during
transportation, especially if the trip takes
longer than 30 minutes.
1. Pull out.
2. Slide to “REV” (reverse).
3. Release.
1. Off
1
U8JA11E0.book Page 56 Monday, June 14, 2010 10:22 AM