Filter
Top Products
Control functions
43
ESU11046
Adjusting the control rods
The weight transfer can be adjusted by turn-
ing the adjuster on the control rod (RS90GT /
RS90LTGT) or the adjusting nuts on the con-
trol rods (RST90 / RST90GT).
RS90GT / RS90LTGT
1. Check the control rod length using the
scale on the special wrench as shown.
TIP
In order to obtain a precise measurement, the
special wrench corner should touch the con-
trol rod adjuster, and the locknut must be
turned so that one of its notches aligns with
the wrench allowing the wrench to fit horizon-
tally on the control rod.
TIP
Use the special wrench in the owner’s tool kit
to make this adjustment.
2. Loosen the locknut.
3. To increase weight transfer, turn the ad-
juster in direction (a), and to decrease
weight transfer, turn it in direction (b).
WARNING! Never adjust the control
rod beyond the range of the scale on
the special wrench, otherwise the con-
trol rod could be damaged, which
could lead to an accident or injury.
[EWS00181]
4. Tighten the locknut while holding the ad-
juster in place.
TIP
Make sure that the special wrench is securely
fitted on the locknut.
Compression damping force setting:
Minimum (soft):
12 click(s) in direction (b)*
Standard:
6 click(s) in direction (b)*
Maximum (hard):
2 click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
1. Special wrench corner
2. Control rod adjuster
3. Scale range
4. Special wrench
5. Control rod length
Min Max
34
5
1
2
1. Locknut
2. Control rod adjuster
U8JA11E0.book Page 43 Monday, June 14, 2010 10:22 AM