Filter
Top Products
2007 Volvo XC90
- Connect the two sections of the jack's crank.
- Insert the hooked end of the crank in the spare wheel retaining attachment (see the illustration below).
- Lower the spare wheel under the vehicle by turning the crank counterclockwise until it is not possible
to turn it further.
- Pivot the toggle at the end of the cable 90 degrees to release it from the spare wheel
- Crank up the cable again by turning the crank clockwise.
CAUTION!
When the spare wheel is mounted on the vehicle, the retaining cable could damage the underside of
the vehicle if it is not retracted.
- Place the wheel with the flat tire in the vehicle's cargo compartment.
NOTE: The space under the vehicle is designed to hold the special spare wheel only. Other full-size
wheels will not fit in this compartment.
Returning the spare wheel to the storage compartment
- Use the crank (turn it counterclockwise) to lower the spare wheel's retaining cable.
- Pass the toggle at the end of the cable through the center hole in the spare wheel. Pivot the toggle 90
degrees so that when raised, the wheel will rest on the toggle.
- Retract the retaining cable slightly by slowly turning the crank clockwise several times.
- Position the wheel so that it is not obstructed by components in the exhaust system.
pg. 168 Wheels and tires
Changing wheels
- Continue to raise the wheel by turning the crank clockwise. Raise the wheel a little bit at a time and
file:///K|/ownersdocs/2007/2007_XC90/07xc90_07.htm (19 of 23)12/30/2006 5:53:47 PM