Filter
Top Products
2007 Volvo XC90
- Place the jack on the ground, under one of the attachment points (see the illustration on the previous
page) and crank while simultaneously guiding the jack's attachment bracket onto the attachment point
(see illustration above) The base of the jack must be flat on a level, firm, non-slippery surface. Before
raising the vehicle, check that the jack is still correctly positioned in the attachment.
- Raise the vehicle until the wheel to be changed is lifted off the ground.
- Unscrew the wheel bolts completely and carefully remove the wheel so as not to damage the threads on
the studs.
NOTE: To avoid excessive wear and the necessity of rebalancing, mark and reinstall wheels in the same
location and position as before removal. To lessen the chance of imbalance, each wheel hub is equipped
with a guide stud to ensure that a removed wheel can be reinstalled in its original position (as when
changing over to winter tires/wheels).
Installing the wheel
- Clean the contact surfaces on the wheel and hub.
- Lift the wheel and place it on the hub.
- Install the wheel bolts and tighten hand-tight. Using the lug wrench, tighten crosswise until all bolts are
snug.
- Lower the vehicle to the ground and alternately tighten the bolts crosswise to 102 ft. lbs. (140 Nm).
- Install the wheel cap (where applicable).
pg. 171 Wheels and tires
Changing wheels
file:///K|/ownersdocs/2007/2007_XC90/07xc90_07.htm (22 of 23)12/30/2006 5:53:47 PM