Filter
Top Products
2007 Volvo XC90
initial position by hand.
When changing lanes
The driver can automatically flash the turn signals 3 times by:
● Moving the turn signal lever up or down to position 1 and releasing it.
● Moving the lever up or down to position 2 and immediately back to its original position.
NOTE:
● This automatic flashing sequence can be interrupted by immediately moving the lever in the opposite
direction.
● If the turn signal indicator flashes faster than normal, check for a burned-out turn signal bulb.
High/low beam headlights
Continuous high beams
- Turn the ignition key to position II.
- With the light switch (1) in position
, (see page 55) pull the turn signal lever toward the steering
wheel (position 4) to toggle between high and low beams (this also applies on models equipped with the
optional Active Bi-Xenon headlights).
High beam flash
- Turn the ignition key to position II.
- Pull the turn signal lever to position 3. The high beams will remain on until the lever is released.
Home safe lighting
When you leave your vehicle at night, you can make use of the home safe lighting function to illuminate
the area in front of the vehicle.
- Remove the key from the ignition switch.
- Pull the direction indicator lever as far as possible towards the steering wheel (to position 4) and
release it.
- Exit the vehicle and lock the doors. The headlights and parking lights will illuminate and remain on for
30
1
, 60 or 90 seconds. The time interval can be changed by an authorized Volvo retailer.
1. Factory setting
pg. 59 Instruments and controls
Right-side steering wheel lever
file:///K|/ownersdocs/2007/2007_XC90/07xc90_02.htm (18 of 40)12/30/2006 5:53:37 PM