Volvo XC90 Automobile User Manual


 
2007 Volvo XC90
How do states use OBD II for emission inspections?
Many states connect a computer directly to a vehicle's OBD II system. The inspector can then read
"faults." In some states, this type of inspection has replaced the tailpipe emission test.
How can my vehicle fail OBD II emission inspection?
Your vehicle can fail OBD II emission inspection for any of the following reasons.
If your Check Engine (MIL) light is lit, your vehicle may fail inspection.
If your vehicle's Check Engine light was lit, but went out without any action on your part, OBD II will
still have a recorded fault. Your vehicle may pass or fail, depending on the inspection practices in your
area.
If you had recent service that required disconnecting the battery, OBD II diagnostic information may
be incomplete and "not ready" for inspection. A vehicle that is not ready may fail inspection.
How can I prepare for my next OBD II emission inspection?
If your Check Engine (MIL) light is lit - or was lit but went out without service, have your vehicle
diagnosed and, if necessary, serviced by a qualified Volvo technician.
If you recently had service for a lit Check Engine light, or if you had service that required
disconnecting the battery, a period of driving is necessary to bring the OBD II system to "ready" for
inspection. A half-hour trip of mixed stop-and-go/ highway driving is typically needed to allow OBD II
to reach readiness. Your Volvo retailer can provide you with more information on planning a trip.
Maintain your vehicle in accordance with your vehicle's maintenance schedule.
pg. 183 Maintenance
Working on your vehicle
Note the following before you begin working on your vehicle:
Battery (see also page 192 for more information on handling the battery)
Ensure that the battery cables are correctly connected and tightened.
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (4 of 37)12/30/2006 5:53:50 PM