Filter
Top Products
52
© 2009 Directed Electronics. All rights reserved.
Remote Learning
Press the
button,3 LED flashes and beeps indicates the remote
is ready to program to the system.
Per the instruction in the Remote Pair section of this guide, follow-
ing step 4 of Placing the system into the remote pair mode. Press
and hold the
button, the siren emits one long chirp to confirm
the remote has been learned.
Battery Information (1-Way)
The 1way companion remote is powered by one 3V coin cell lithium
battery (P/N CR-2032) that should last approximately one year under
normal use.
Battery Replacement
Battery
Cover
Battery
Clip
Rear View
+
1 2
1. Slide the battery cover up by ap-
plying equal pressure at its top and
bottom (the arrow on the cover indi-
cates the direction), remove the cover
from the remote control housing.
2. Gently pry up on the battery to re-
move it from the holder. Insert a new
battery into the holder and under the
clip with the positive (+) side up. Replace the battery cover. The re-
mote control is now ready for use.