Filter
Top Products
38
© 2009 Directed Electronics. All rights reserved.
Table of Zones
Zone # (led flashes) Zone Name
1 Trunk
2 Shock Sensor
3 Door
4 Optional Sensor
5 Ignition
6 Hood
Last Trigger Report
The Last Trigger report displays the two most recent alarm triggers
depending on the system state when requested. When disarmed, the
report will display screens for the two most recent Alarm Zone triggers
since the vehicle was last driven. When armed, the report will display
screens for two most recent Alarm Zone triggers since the system was
armed.
Note
The last trigger report clears when ignition is turned on.
Nuisance Prevention (NPC)
NPC monitors all alarm zones and, if any are triggered excessively,
bypasses them until corrected. If a point of entry (trunk, hood, door)
is left open following a forced entry, it is bypassed. It becomes active
again only after being closed.
Sensors that trigger excessively are bypassed and reported to the
remote via Sensor Status icon in the Status Screen, and by NPC On
screens that are displayed during the Disarm Trigger and Last Trigger
reports.
Bypassed sensors automatically reset after one hour and after the
vehicle is driven. Disarming then re-arming the alarm does not reset
bypassed sensors.