Filter
Top Products
46
© 2009 Directed Electronics. All rights reserved.
Valet Mode
Valet mode can be entered and exited by performing the Remote Valet
command or manually using the vehicle key and the control button.
When entered, the alarm functions are defeated while the conve-
nience features still operate normally.
Arm and Disarm commands lock and unlock the doors while the
LOCKED IN VALET
and
UNLOCK IN VALET
animations and beeps play
to confirm.
Use the following steps to manually enter and exit Valet Mode:
Turn1. the ignition switch On and then Off
Immediately 2. press and release the control button once
The control center LED turns On when entering and Off when 3.
exiting.
Power Save
To reduce power consumption the control center status LED modifies
its output if the vehicle is parked for an extended period. If Armed the
flashing is reduced after 24 hours. When Valet mode is On, the LED
turns off after 1 hour and resets each time the ignition is turned off.
Rapid Resume
If power is ever disconnected by a mechanic or thief, the system will
resume the state it was in at the time of disconnection, when power
is reconnected.
Automatic Remote Updates
The system sends a silent message to all remote controls after any
major action has occurred. When the remote receives this message it
updates the status screen icons. This way all users are able to quickly
review the system status just by accessing the status screen.