Filter
Top Products
INSTALLATION DIRECTIVE MAY 2006
58
V08 ENT M75
-
M11
-
M12
1. Oil discharge control.
Lubricating oil exhaust operations are simplified by the
presence of an electrical control system connected to the JG
connector of the interface wiring harness. Manual control for
exhaust operations is positioned on the front panel unit. For
safety reasons, control is enabled only with the key switch in
the “OFF” position.
1. Not used - 2. Not used.
The module (on request) is connected to the JG1 connector
of the interface wiring harness.
The task of pre-lubricating the engine’s internal components
is managed and controlled by the electronic circuit of the
module when the key switch is placed in “ON” position.
#(!2'%
$)3#(!2'%
1
/&&#(!2'%
%6$)3#(!2'%
/.
%6
1
2
04_037_C
LUBRICATING OIL TRANSFER MODULE PRE-LUBRICATION MODULE
Figure 1 Figure 2
04_036_C