Filter
Top Products
AUTOMATIC DOOR LOCKS
Ⅲ All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
Ⅲ All doors unlock automatically when the ignition switch is placed in the OFF position
(Intelligent Key equipped vehicles) or when the key is removed from the ignition switch
(non-Intelligent Key equipped vehicles).
The automatic lock and unlock functions can be deactivated or activated inde-
pendently of each other. To deactivate or activate the automatic door lock or unlock
system, perform the following procedure:
1. Close all doors.
2. Place the ignition switch in the ON position.
3. Do one of the following within 20 seconds of performing Step #2:
● To change AUTO UNLOCK settings: push and hold the power door lock switch to
the
position (UNLOCK) for more than 5 seconds.
● To change AUTO LOCK settings: push and hold the power door lock switch to
the
position (LOCK) for more than 5 seconds.
4. When activated,the hazardwarning lights willflash twice.When deactivated,the hazard
warning lights will flash once.
5. The ignition switch must be placed in the OFF and ON position again between each
setting change.
WINDSHIELD WIPER/WASHER SWITCH
Ⅲ The ignition switch must be in the ON position to
activate the windshield wipers.
Ⅲ Move the lever to the following positions to oper-
ate the windshield wipers:
Intermittent (INT) – Front wipers operate
intermittently and can be further adjusted by
twisting the time control ring
.
Low Speed (LO) – Continuous low-speed
operation of front wipers.
High Speed (HI) – Continuous high-speed
operation of front wipers.
Mist (MIST) – Lift the lever up for one sweep of the front wipers.
Rear Wipers (REAR) – Twist the end section to operate the first (INT) or second
(ON) speed settings for the rear wipers.
Ⅲ The washer function activates the washer fluid and several sweeps of the wipers:
● For FRONT WASHER, pull lever toward you.
● For REAR WIPER, push lever away from you.
4