Filter
Top Products
TIP UP FOR EASY ENTRY TO THE 3RD ROW
Ⅲ The 2nd row outboard seats can be tipped forward
for easyentry or exit fromthe 3rd row benchseat. To
enter the 3rd row, lift up on the latch
located
on the upper corner of the seatback on the 2nd row
outboard seats and fold the seatback forward at an
angle at the seat base. This will release the back of
the seat so it may be tipped forward.
Ⅲ Then,lift upon the lowercorner of theseat base and
tip the 2nd row outboard seat forward. To exit the
3rd row bench seat, lift up on the same latch and
fold the seatback forward onto the seat base. Then,
lift up on the seat base and tip it forward.
FOLDING THE 3RD ROW SPLIT BENCH SEAT (if so equipped)
Ⅲ To fold the seats flat, disconnect and secure the
center seat belt and tongue from the retractor base.
Ⅲ Pull up on the latch
, located on the outside
corner of each seatback, and fold the seatback
forward over the seat base.
Ⅲ To raise the seats, lift the seatbacks and make sure
they are fully latched in the upright position.
3RD ROW POWER FOLDING SEATS (if so equipped)
The 3rd rowpower folding seat controls arelocated on the 2nd rowpassenger
(right-hand) side cup holder console and on the passenger (right-hand) rear
quarter trim panel area (behind 3rd row seating).
The left-side switch controls the driver’s side 3rd row bench seat. The
right-side switch controls the passenger’s side 3rd row bench seat.
The power folding seats only operate when the transmission is in the
P (Park) or N (Neutral) position.
Ⅲ To fold down the 3rd row seats using the power folding seat switch, push
the down portion
of the switch.
Ⅲ To return the seats to the normal upright position, push the up
portion
of the switch.
Ⅲ A warning beep will sound 5 times if the seat is not in the full upright or folded position
when the ignition switch is placed in the ON position.
21