Filter
Top Products
35 Chapter 4
Option (F) Format Flash
Choose this option to format the flash. This will not overwrite EBOOT or
EBOOT parameters.
Option (L) Launch Existing Flash Resident Image Now
Choose this option to exit the menu, save any applicable changes that
were made and then launch the previously programmed flashed image.
Option (M) Display Mode Setup
Mode (0) (800x600), Mode (1) (640x480),
Mode (2) (1024x768), Mode (3) (320x24)
Choose this option to configure the display resolution. The default
TREK-725 configuration is Mode (0).
Option (R) Reset to Factory Default Configuration
Choose this option to reset user-configurable settings to the following
factory defaults.
Note: When you reset the user-configurable settings, you must change
option (C) Ethernet debugging setting from Enable to Disable for boot-
up Windows CE successfully.
IP address 192.168.80.2
Subnet mask 255.255.0.0
NPE0 MAC Address 80-86-22-22-22-22
NPE1 MAC Address 80-86-33-33-33-33
RNDIS MAC Address 80-86-44-44-44-44
Boot delay 5 seconds
DHCP Enabled
Program RAM image into
FLASH
Disabled
Check image signature(s) Disabled
Automatic Startup Behavior Download new image via Ethernet
Boot device order PCI NIC RT8139D -> NPE0 -> NPE1
Ethernet debugging Enabled