Filter
Top Products
Trek-725 User Manual 26
3.8 Installing the Universal Arm
1. Press latches at the same time and then rotate support-1 until you
can see both of the screw holes.
2. Rotate support-2 until the angle is the same as support-1.
3. Use four M4x8L screws and attach the U-Arm with the TREK-725.
The 4 stainless screws can be found in the universal arm's box.
4. Use latches adjust the angle of TREK-725 (every 14.4° on 360°).
Figure 3.12: Universal Arm
Note Support-1 can be on the right or left.
Screw-M4x8L
(x4)
Support-2
Support-1
TREK-725
Latch