Sony NVX-P1 GPS Receiver User Manual


 
22
Notes on the lithium battery
Keep the lithium battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
Wipe the battery with a dry cloth to assure a good
contact.
Be sure to observe the correct polarity when
installing the battery.
Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
Fuse replacement
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse blows
again after replacement, there may be an internal
malfunction. In such a case, consult your nearest
Sony dealer.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as this
could damage the unit.
Specifications
Navigation unit
Operating temperature: 0 ºC to 55 ºC
(32 ºF to 131 ºF)
Storage temperature: –40 ºC to +70 ºC
(–40 ºF to +158 ºF)
Dimensions: Approx. 165 × 76 × 43.7 mm
(6.5 × 3.0 × 1.7 in) (w × h × d)
Mass: Approx. 370 g (13.1 oz)
Power requirements:
DC 5 V
(from the supplied 12 V car battery adaptor
(negative earth)/AC power adaptor)
Connection terminal:
External aerial jack
Power jack
USB jack
GPS receiver
Location method: All in view method
Maximum number of tracking satellites: 12 satellites
Speaker
Maximum power output: 0.25 W
Optional accessory
External GPS Antenna: VCA-39
Design and specifications are subject to change
without notice.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of
in fire.
Fuse (2 A)
To remove
To tighten
Lead-free solder is used for soldering all the parts
including circuit component electrodes.
Halogenated flame retardants are not used in
printed wiring boards.