Filter
Top Products
SECTION 1
PREPARATION FOR USE
Alternator Unpacking and Removal from Shipping Skid
1 Cut Straps
2. Lift Cardboard Shtpplng
Carton Straight Up and
Off Shipping Pallet
Cardboard Insert
Alternator Localed Here
Kit Located Here
Shipping Pallet
¢ "4
| Alternator Cradle
Wood Sh,pping PatIet " !.j ]
?
Washer
!
_b Bolt
1oThe alternator is bolted to a wood shipping
pallet, The cardboard is then set into position
and retained with straps., Location of alter-
nator and wheel kit in shipping carton is
shown above. To remove carton, cut the
straps and lift cardboard carton straight up
and off pallet°
PARTS SHIPPED WITH ALTERNATOR
2. Two 1/4 inch bolts and hex nuts retain the
alternator cradle to the wood shipping palleL
Use two 7/16 inch wrenches to remove bolts
and hex nuts° Alternator can then be removed
from wood pallet°
The following items are shipped with the alternator and must be installed or assembled. To order
additional items listed below, refer to REPAIR PARTS section of this manual.
1_ Battery Hold-Down Bracket with retaining hardware
2. Wheel Kit
3. One 5 gallon Fuel Tank with retaining strap
4o One 120 Volt, 3-Prong, 30 Amp Connector Plug
5. One 240 Volt, 20 Amp, 4-Prong Connector Plug
The battery retaining bracket and hardware
are shown at right° The 12 volt battery is to be
supplied by the customer° Make sure all of
the following have been received:
[_ Item
D1
N2
_3
E34
D5
Description
Bracket (1 Req'd)
Bolt - V4-20 x 7" long (2 Req'd)
Flatwasher- %" (2 Req'd)
Lockwasher - 1/4" (2 Req'd)
Wing Nut - _/4-20 (2 Req'd)
Battery Locating Bracket ITEM 5
__ ITEM 4
@_.--.f
ITEM 3
_ ITEM I
t2 Volt Battery ITEM 2
(Customer Supplied )
5