Filter
Top Products
BATTERY INSTALLATION
A 12 Volt automotive type storage battery is
required, and must be purchased separately.
Battery should have a 32 amplhour (or higher)
capacity° Install the battery as follows:
_ CAUTION
install the battery and connect battery
cables EXACTLY as outlined in this
Manual. Incorrect battery cable connec-
tions will damage the engine ignition
system andlor the alternator battery charg-
ing circuit,
1. Set battery into place on cradle against the
battery locating bracket.
2. Set the Bracket (Item 1) onto top of battery.
MAKE SURE BRACKET DOES NOT CON*
TACT BATTERY POSTS.
3o Retain Bracket with two t/4-20 x 7" long
bolts (Item 2), Flat Washer (Item 3), Lock
Washer (item 4), and Wing Nuts (Item 5). Snug
both Wing Nuts down, but DO NOT OVER-
TIGHTEN..
BATTERY CONNECTIONS
1o The black battery cable is connected to a
grounding lug. Make sure the cable is TIGHT,
then connect the other end of black cable to
battery post indicated by a NEGATIVE, NEG
or (-)o
Battery Locating Bracket
ITEM 5
h
t2 Volt Battery fl
(Customer Supplied )
ITEM 2
Grounding Lug For Negative
Battery Cable
Black Battery Cable
..To NEGATIVE, NEG or (-)
Battery Post
2. The red battery cable is connected to the
starter solenoid° Be sure the hex nut that re-
tains the cable is tight. Connect the other end
of the red cable to the battery post indicated
by a POSITIVE, POS or (4-).
Red BatteQ
Cable
To
POSITIVE, POS
or (+ ) Battery
Post
To
Starter
Motor
9