Filter
Top Products
LUBRICATION
CAUTION
Engines are shipped without oil. Any attempt to start the engine before the recommended
oil has been properly added may result in an engine failure.
Service the engine crankcase with a high quality detergent oil having a classification which in-
cludes"For Service MS, SC, SD or SE", and as recommended in the following CHART. Oil recom-
mendations are the result of extensive testing° use no special additives with the recommended
oilo
Recommended Oil
l t !,
t
oFT20 o 29 49 _ ................8o mo
°C- 30 - 20..............!0 ........... 0 10 20 30 40
"TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
*if not available, a synthetic oil may be used having- 5W-30 or 5W-40 viscosity.
Fill engine crankcase with oil as follows:
1. Remove Oil Dipstick from Oil Filler neck.
2. Make sure unit is LEVEL.
3. Pour a measured 31/2 pints (56 ounces or'
1o65 Liters) of the recommended oil into Filler'
Neck_ DO NOT OVERFILL.
CAUTION
If engine crankcase is overfilled, a smoking
condition will result as the engine tries to
discharge the surplus oil.
4. Reinstall Oil Dipstick ALL THE WAY into
Oil Filler Neck, then remove° Oil should be at
Dipstick FULL mark° if oil level is BELOW
Dipstick FULL mark, add oil as required to
bring level to FULL mark°
A
CAUTION
Do not operate engine
with oll level below
"add 1 pint" mark.
Oft Dipstick
Oii FIHer Neck
FULL
ADD 1 PINTt_
5o if oil level is ABOVE the Dipstick FULL
mark, remove Oil Drain Plug at base of engine
and drain excess oil into asuitable continer_
Then reinstall drain plug.
6. When oil level is at Dipstick FULL mark,
reinstall Dipstick into Filler Neck° MAKE
SURE DIPSTICK IS TIGHT.
8
OIL _'
DRAIN
PLUG