Filter
Top Products
[ 86 ]
Note:
Check with your service provider to make sure this service is
available in your network.
1
Make a call to the first participant as usual. When you are ready to
place a call to the next party:
2
Press
Options
, then press
New call
.
3
Enter the number and press the Send key (or press
Search
to recall
the number from the phone book).
4
Press the Send key again to connect both parties.
5
To end the call, press the End key. This action disconnects both parties.
End calls
To end a conference call (disconnect with all callers), press the End key.
Or you can also press
Options
, then select
End all calls
.
Disconnect second party
While all three parties are connected, pressing the Send key disconnects
the second caller, keeping the first party’s call active.
Disconnect first party
If you wish to disconnect with the first party and remain connected to the
second party, have the first party terminate the call on his/her end.
• SEND OWN CALLER ID WHEN CALLING
This feature allows you to block caller ID when you call someone (your
number will not be displayed on their caller ID). This feature may only
be effective when calling a number equipped with caller ID.
Note:
This feature is available only when supported by the wireless
network and may not function if you are roaming.
Important:
This feature works on a call-by-call basis. You must
enable this feature each time you want to block the sending of
your own number to the recipient’s caller ID.