Filter
Top Products
944 Engine/Cylinder Head, Valve Drive
15
Installing Camshaft Seal
1.
Place sealing washers in bearings and
install bearing bridge with Loctite 574.
Tightening torque 20 Nm (15 ftlb).
87/465
2.
After torquing the bearing bridge, install
sealing cover with the aid af Special Tool
9234
86/925
Engine installed
Note:
If the sealing cover af an engine leaks with
the engine installed, the procedure for
installing the cover is as follows:
1.
Place camshafts and sealing washers in
bearing.
2. Apply Loctite 574 to bearing bridge and
install. Place a 0.20 mm feeler gauge
between bearing bridge and cylinder
head
and tighten botts slightly by hand.
928/01
3.
Apply a light film af oil to sealing cover
and
press an by hand. Tighten bearing bridge
to 20 Nm (15 ftlb).
Installing Camshafts Seal
Printed in Germany - XVII, 1988
15 - 112a