Filter
Top Products
10
Engine/Crankcase 944
REMOVING AND INSTALLING ENGINE (MANUAL TRANSMISSION)
Remove by lowering engine from car.
The bell housing remains attached
to the engine.
Removing
1.
Align lifting platform pads
beneath jacking points and raise
car.
2.
Place protective covers on
fenders.
3.
Unbolt and remove front wheels.
4.
Disconnect battery/bodywork
ground lead. Disconnect battery
positive lead. Disconnect wire
harness and push both cables with
rubber grommets through splash
wall. Open cable clips.
5.
Unbolt panel in passenger-side
footwell and remove. Unbolt
carrier plate for DME control
unit and disconnect control-unit
plug. Disconnect 8-pin connector.
6.
Slacken hose clamp for fuel
return line and disconnect hose.
Disconnect fuel feed while
countering. Detach cable from
tempostat serve motor. Disconnect
series resistor/injection nozzle
connector.
10 - 102 Removing and Installing Engine Printed in Germany