Filter
Top Products
944 Engine/Crankcase
10
19.
Detach Poly-rib belt tensioner
from air-conditioning compressor
and remove belt. Remove
compresor from bracket and place
to one side. (Do not disconnect
refrigerant hoses).
20.
Unbolt stabilizer with bracket
from body and from control arms
and remove. Disengage left and
right tie rods.
21.
Slacken hose clamps between ATF
cooler and steering and
disconnect line.
22.
Disconnect servo pump from
bracket, moving spacer sleeve
forward to remove. Leave servo
pump hanging from steering.
23.
Disconnect left and right
control arms from front-axle
traverse and rear bearings and
pull forward to remove. (Do not
slacken bolts in bearing bracket).
24.
Unbolt universal joint from
steering detach hydraulic motor
mount from engine supports and
lower front-axle cross member
complete with steering and servo
pump from car.
Printed in Germany - XIII, 1987 Removing and Installing Engine 10 - 105