Filter
Top Products
ENGINE
3.19
4. Follow the manufacturers instructions provided
with the valve seat cutters in the Valve Seat
Reconditioning Kit (PN 2200634). Abrasive stone
seat reconditioning equipment can also be used.
Keep valves in order with their respective seat.
NOTE: Valve seat width and point of contact on the
valve face is very important for proper sealing. The
valve must contact the valve seat over the entire
circumference of the seat, and the seat must be the
proper width all the way around. If the seat is uneven,
compression leakage will result. If the seat is too
wide, seat pressure is reduced, causing carbon
accumulation and possible compression loss. If the
seat is too narrow , heat transfer from valve to seat is
reduced and the valve may overheat and warp,
resulting in burnt valves.
5. Once thoroughly heated, place cylinder head on
blocks of wood which will allow the old guides to
be removed.
6. Using valve guide driver, drive guides out of the
cylinder head from the combustion chamber side.
Be careful not to damage guide bore or valve seat
when removing guides.
7. Place cylinder head on cylinder head table.
NOTE: Be sure cylinder head is still at 212° F
(100° C) before installing new guides.
8. Place a new guide in the valve guide installation
tool and press guide in to proper depth. Check
height of each guide above the cylinder head (A).
Refer to specifications.
NOTE: Theguidecanalsobedrivenintothe
proper depth. Inspect the guide closely for cracks
or damage if a driver is used.
A
Valve Guide Installed Height
Valve Guide Height:
.681-.689I (17.3-17.5 mm)
Reaming The Valve Guide
9. Allow cylinder head to cool to room temperature.
Apply cutting oil to the reamer. Guides should be
reamed from the valve spring side of the cylinder
head. Ream each guide to size by turning the
reamer clockwise continually. Continue to rotate
reamer clockwise during removal of the tool.
10. Clean guides thoroughly with hot soapy water and
a nylon brush. Rinse and dry with compressed
air. Apply clean engine oil to guides.
VALVE SEAT
RECONDITIONING
1. Install pilot into valve guide.
2. Apply cutting oil to valve seat and cutter.