Novatel DL-L1 GPS Receiver User Manual


 
1 Overview
DL User Manual Rev 3 13
Table 2: Feature Summary - DL Models
General
DL-L1 DL-RT20S DL-L2 DL-RT2
L1 Channels (C/A code) & L2 Channels (P code) 12 & 0 12 & 0 12 & 12 12 & 12
Pseudorange measurements
Full-wavelength L2 carrier measurements
× ×
Ionospheric corrections in position calculations
2.5-bit sampling
Patented Narrow Correlator tracking technology
5 Input / Output strobe signals: mark input (position & time), 1PPS
timing output, measure output, programmable variable-frequency
output, solution status output
Fast re-acquisition
Peripheral power supply output COM2
Output Data Log Formats
DL-L1 DL-RT20S DL-L2 DL-RT2
NovAtel-proprietary ASCII and binary
NMEA Standard
RINEX Standard
RTCM Standard: Types 1,2,3,9,16,59N
RTCA Standard: Types 1,7
Data Logging Rates (per second)
DL-L1 DL-RT20S DL-L2 DL-RT2
Computed Data: Position, speed, direction, & clock offset 10 10 / 5 5 5
Measured Data (Observations): Pseudorange & carrier phase 20 20 10 10
Receiver Control
DL-L1 DL-RT20S DL-L2 DL-RT2
Clock drift correction
Ability to save receiver configuration settings, & almanac
Reset (hardware or software activated)
Serial port control
Datum (table or user-definable)
Magnetic variation correction
Undulation (table or user-definable)
Position, height & velocity constraints
Satellite lockout, elevation cut-off and health control
OPERATING MODES
Whenever the DL is connected to a power source (regardless of whether the DL is turned on or off), it detects
whether there is a host computer connected to one of its serial ports. For example, this host computer could be a PC
running NovAtel SoftSurv Utilities software, or a data logger running suitable software. If a host computer is found, the
DL enters Manual mode and waits for a command; otherwise, the DL enters Automatic mode and operates according to
stored commands.
Manual Operation: Among other things, a host computer can transmit scheduling and logging parameters,
receive collected data, and turn the DL on or off. In this mode, the DL does not need to be tracking satellites, or
even have an antenna connected to it.
Automatic Operation: Once the DL receives configuration commands from a host computer, it operates
according to these parameters. Up to a weeks worth of data collection can be configured in advance.