Filter
Top Products
5. After attaching the child restraint, test it be-
foreyouplacethechild init.Pushitfrom side
to side while holding the child restraint near
the seat belt path. The child restraint should
not move more than 1 inch (25 mm), from
side to side. Try to tug it forward and check
to see if the seat belt holds the restraint in
place. If the restraint is not secure, tighten
the seat belt as necessary, or put the re-
straint in another seat and test it again. You
mayneedto tryadifferent childrestraint.Not
all child restraints fit in all types of vehicles.
6. Check to make sure the child restraint is
properly secured prior to each use. If the
seat belt is not locked, repeat steps 3
through 5.
INSTALLING TOP TETHER STRAP
(Rear bench seat)
To access the anchor points
᭺
2
behind the rear
bench seat, tilt the rear seatback forward by
lifting up on the pull strap
᭺
1
behind the seat-
back.
Forward-Facing — step 5
WRS0917
Anchor point access
LRS0392
1-40 Safety—Seats, seat belts and supplemental restraint system