Filter
Top Products
19
4. Hold down both buttons until the indicator light on the HomeLink
®
flashes, changing from
a “slow blink” to a “rapidly flashing blink.” This could take up to 90 seconds. When the indicator
light flashes rapidly, both buttons may be released. The rapidly flashing light indicates
successful programming. To activate the garage door or other programmed device, press
and hold the programmed HomeLink
®
button - releasing when the device begins to activate.
5. If the indicator light on the HomeLink
®
blinks rapidly for 2 seconds and then turns solid,
HomeLink
®
has picked up a “rolling code” garage door opener signal. You will need to
proceed with the next steps to train the HomeLink
®
to complete the programming, which
may require a ladder and another person for convenience.
6. Press and release the “smart” or “learn” program button located on the garage door opener’s
motor to activate the “training mode.” This button is usually located near the antenna wire that
hangs down from the motor. If the wire originates from under a light lens, you will need to
remove the lens to access the program button.
NOTE: Once you have pressed and released the program button on the garage door
opener’s motor and the “training light” is lit, you have 30 seconds in which to perform
step 7. Use the help of a second person for convenience to assist when performing this step.
7. Within 30 seconds of pressing and releasing the garage door opener program button,
firmly press and release the HomeLink
®
button you’ve just programmed. Press and release
the HomeLink
®
button up to 3 times to complete the training.
8. Your HomeLink
®
button should now be programmed. (To program the remaining HomeLink
®
buttons for additional door or gate openers, follow steps 2-8 only.)
BLUETOOTH
®
HANDS-FREE PHONE SYSTEM
(vehicles without navigation - if so equipped)
With an overhead microphone and sound transmitted
through the audio system speakers, the Bluetooth
®
Hands-free Phone System utilizes Bluetooth
®
wireless technology and voice recognition to
provide hands-free cellular phone communication.
SYSTEM OPERATING TIPS
Close all windows. Surrounding noises may interfere with
system operation and performance.
Press the
button on the steering wheel to activate voice recognition.
Wait for the tone before speaking.
Begin speaking a command within 5 seconds of the tone.
Speak in a clear and natural voice without pausing between words.
To go back to the previous command, say “Go back” or “Correction.”
To cancel a voice recognition session, simply wait 5 seconds; say “Cancel,” “Quit” or press
the button.
To increase or decrease the volume of the voice prompts, press the VOL (volume) control
switch + or – on the steering wheel or turn the POWER/VOLUME knob on the audio
system while the system is responding.