Filter
Top Products
SETTING UP YOUR PHONEBOOK – ADDING NEW ENTRIES
Each paired phone has its own dedicated phonebook. Each phonebook can store up to 40
names. Each name can have up to 4 locations/numbers: Home, Office, Mobile, and Other.
NOTE: The vehicle must be stationary when adding new entries.
1. Press the
button and wait for the tone.
2. Say “Phonebook”.
3. Wait for the tone, then say “New entry”.
4. When prompted, say the name for the new entry. For example, say “Michelle”. If the
name is too short or too long, or if it sounds too much like a name that is already stored
in the phonebook, the system tells you and prompts you to say a name again. Choose a
new name.
5. Say “Yes” or “No” when the system asks you to confirm the name is correct.
6. Say a location (“Home,” “Office,” “Mobile” or “Other”) when the system asks you to
provide one. The system acknowledges the location.
Ⅲ By Voice command - When prompted, say a phone number for the location. For
example, say “five five five one two one two”. The system repeats the number and
prompts you for the next command.
Ⅲ By Bluetoothா transfer - When prompted, say “Transfer entry”. The system acknowl-
edges the commandand asks you toinitiate the transfer fromthe phone handset. The
new contact phone number will be transferred from the cellular phone via the
Bluetoothா communication link. The transfer procedure varies according to each
cellular phone. See the cellular phone owner’s manual for details.
7. Say “Store” when you are finished entering numbers. The system confirms the name,
location, and number.
8. Say “Yes”or “No”when the systemasks if youwould like tostore another locationfor the
same name. If you donot respond to the system prompt, the system ends theNew Entry
session.
MAKING A PHONE CALL
1. Press the button.
2. After the tone, do one of the following:
Ⅲ Say “Call [name] [location]”. For example, say “Call Michelle Home”.
Ⅲ Say “Call [number]”. For example, say “Call 123-456-7891”.
Ⅲ Say “Redial” to redial the previous phone number called by the system.
Ⅲ Say “Call International” to dial more than 10 digits or any special characters.
RECEIVING/ENDING A PHONE CALL
When you receive a phone call, a ring tone sounds through the audio system.
Ⅲ To accept the call, press the
button. To reject the call, press the button.
Ⅲ To hang up the phone at the end of a call or to disconnect during call placement, press
the
button.
19