Filter
Top Products
3. Using both hands, simultaneously press and hold both the HomeLinkா button you want
to program and the hand-held transmitter button. DO NOT release the buttons until
step 4 has been completed.
4. Hold down both buttons until the indicator light on the HomeLinkா flashes, changing
from a “slow blink”to a “rapidly flashing blink”. This could take up to 90 seconds. When
the indicator light flashes rapidly, both buttons may be released. The rapidly flashing
light indicates successful programming. To activate the garage door or other pro-
grammed device, press and hold the programmed HomeLinkா button - releasing when
the device begins to activate.
5. If the indicator light on the HomeLinkா blinks rapidly for two seconds and then turns
solid, HomeLinkா has picked up a “rolling code” garage door opener signal. You will
need to proceed with the next steps to train the HomeLinkா to complete the program-
ming, which may require a ladder and another person for convenience.
6. Press and release the “smart” or “learn” program button located on the garage door
opener’s motor to activate the “training mode”. This button is usually located near the
antenna wire that hangs down from the motor. If the wire originates from under a light
lens, you will need to remove the lens to access the program button.
NOTE: Once you have pressed and released the program button on the garage
door opener’s motor and the “training light” is lit, you have 30 seconds in which
to perform step 7. Usethe help of a second person for convenienceto assist when
performing this step.
7. Quickly within 30 seconds of pressing and releasing the garage door opener program
button, firmly press and release the HomeLinkா button you’ve just programmed. Press
and release the HomeLinkா button up to three times to complete the training.
8. Your HomeLinkா button should now
be programmed. (T
o program the remaining
HomeLinkா buttons for additional door or gate openers, follow steps 2-8 only.)
BLUETOOTHா HANDS-FREE PHONE SYSTEM (Without Navigation
System – if so equipped)
With an overhead microphone and sound
transmitted through the audio system
speaker, the Bluetoothா Hands-Free Phone
System utilizes Bluetoothா wireless technol-
ogy and voice recognition to provide hands-
free cellular phone communication.
SYSTEM OPERATING TIPS
Ⅲ Close all windows. Surrounding noises
may interfere with system operation and
performance.
Ⅲ Press the
button on the steering wheel to activate voice recognition.
Ⅲ Wait for the tone before speaking.
Ⅲ Begin speaking a command within 5 seconds of the tone.
Ⅲ To go back to the previous command, say “Go back” or “Correction”.
Ⅲ To cancel a voice recognition session, simply wait 5 seconds, say “Cancel”or “Quit”, or
press the
button.
17