Filter
Top Products
2 VHF 7200 US and 7200 EU Operation Manual
NAVMAN
IMPORTANT:
1. DSC functions will not operate until your MMSID has been entered. Refer to section 4.2
for details.
2. The radio channels installed into the Navman VHF radio may vary from country to
country, depending upon the model, and government or national communications authority
regulations.
3. Navman NZ Ltd recommends that you check the radio operating licensing requirements
of your country before using the Navman VHF radio. The operator is solely responsible for
observing proper radio installation and usage practices.
4. A DSC warning label is supplied with the 7200 US. To comply with FCC regulations, this
label must be affi xed in a location that is clearly visible from the operating controls of this
radio. Make sure that the chosen location is clean and dry before applying this label.
It is the owner’s sole responsibility to install and use the instrument in such a manner that will not
cause accidents, personal injury or property damage.
Navman NZ Limited disclaims all liability for any use of this product in a way that may
cause accidents, damage or that may violate the law.
Governing Language: This statement, any instruction manuals, user guides and other
information relating to the product (Documentation) may be translated to, or has been translated
from, another language (Translation). In the event of any confl ict between any Translation of
Documentation, the English language version of the Documentation will be the offi cial version of
the Documentation.
This manual represents the Navman VHF 7200 US and 7200 EU radios at the time of printing.
Navman NZ Limited reserves the right to make changes to specifi cations without notice.
Copyright © Navman NZ Limited, New Zealand. All rights reserved. NAVMAN is a registered
trademark of Navman NZ Limited.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide a reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try and correct the interference by one or more of the following
measures:
•reorient or relocate the receiving antenna.
•increase the separation between the equipment and receiver.
•connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•consult the dealer or an experienced radio/TV technician for help.
RF Emissions Notice:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This device’s antenna must be installed in accordance with provided instructions;
and it must be operated with minimum 96 cm spacing between the antennas and all person’s
body (excluding extremities of hands, wrist and feet) during operation. Further, this transmitter
must not be co-located or operated in conjunction with any other antenna or transmitter.