Filter
Top Products
AC3 Series of Engines
22
Testing the module
To test the module:
1. Remove the starter housing by following the proce-
dures described in Chapter 6: Starter.
2. Check the air gap for the module. Set it to 0.010” by
following the steps described in the module section
of this chapter.
3. Disconnect the red wire. See Figure 4.2.
4. Install the starter as described in the starter section
of this chapter.
5. Install the clutch as described in the clutch section
of this chapter.
6. Pull the starter rope with the spark tester still
hooked up to the spark plug wire.
• If there is spark now, test the engine stop switch
and check the red wire for a short to ground.
• If there still in no spark, hold a screwdriver against the magnets on the flywheel to feel if they are mag-
netic. If the magnets are good, replace the module. If not, replace the flywheel.
Figure 4.2
Disconnect the red
wire